Aire Flo Pressure Switch Open With Inducer On. If you can get on the roof safely than i'd remove the cap from the pipe and check in there. Reconnect the wires and vacuum tubes to the new pressure.
Detach one or more vacuum tubes located on the side of the unit. Afraid you might be money ahead to call for service on this one. What does it m;ean by pressure switch is open with inducer on for my gibson furnance model number gl1ra072c12a
It connects directly to the inducer box via a vacuum hose and closes or remains open in response to the pressure value in the draft inducer system. Remove the pipe from the furnace and open hand smack it a few times, see what falls out. If a pressure switch is not jumpered correctly, the furnace will not turn on at all.
Pressure switches are used in a variety of applications. The condensate trap and exhaust vent pipe are both clear. Use a paper clip or small drill bit to clean the hole out.
At this point, the red status light blinks three times, which looks like that means the pressure switch is open with inducer on. Still doesn't expain why the fault shows even with the pressure switch jumped though. How to test pressure switch on a furnace.
If you can get on the roof safely than i'd remove the cap from the pipe and check in there. With the hose connected to the pressure switches and unplugged at the other end lightly suck and push air with your mouth to see if you hear clicking in pressure switch, if air runs right through it freely, the diaphragm inside is ruptured, then replace press switches, sometimes water get inside them and they get stuck, after the sucking it may have released it and it will. Lockout due to no ignition:
Blower draft inducer, flue exhaust 1/30hp 3000rpm 115v lennox. Based on another post of the same error code, i switched the unit off, unplugged one of the wires on the pressure switch, then switched the unit on, waited a few seconds and plugged the wire back into the pressure switch. Make sure the tube is clean.
Comments
Post a Comment